class documentation

Undocumented

Method __init__ Undocumented
Method childConnectionLost Undocumented
Method childDataReceived Undocumented
Method connectionLost Undocumented
Method getHost Similar to getPeer, but returns an address describing this side of the connection.
Method getPeer Get the remote address of this connection.
Method loseConnection Close my connection, after writing all pending data.
Method loseWriteConnection Undocumented
Method pauseProducing Undocumented
Method readConnectionLost Indicates read connection was lost.
Method registerProducer Register to receive data from a producer.
Method resumeProducing Undocumented
Method startReading Compatibility only, don't use. Call resumeProducing.
Method stopProducing Stop producing data.
Method stopReading Compatibility only, don't use. Call pauseProducing.
Method unregisterProducer Stop consuming data from a producer, without disconnecting.
Method write Write some data to the physical connection, in sequence, in a non-blocking fashion.
Method writeConnectionLost Indicates write connection was lost.
Method writeSequence Write an iterable of byte strings to the physical connection.
Instance Variable disconnected Undocumented
Instance Variable disconnecting Undocumented
Instance Variable protocol Undocumented
Method _readConnectionLost Undocumented
Method _writeConnectionLost Undocumented
Instance Variable _reader Undocumented
Instance Variable _writer Undocumented
def __init__(self, proto, stdin=0, stdout=1, reactor=None): (source)

Undocumented

def childConnectionLost(self, fd, reason): (source)

Undocumented

def childDataReceived(self, fd, data): (source)

Undocumented

def connectionLost(self, reason): (source)

Undocumented

def getHost(self): (source)

Similar to getPeer, but returns an address describing this side of the connection.

Returns
An IAddress provider.
def getPeer(self): (source)

Get the remote address of this connection.

Treat this method with caution. It is the unfortunate result of the CGI and Jabber standards, but should not be considered reliable for the usual host of reasons; port forwarding, proxying, firewalls, IP masquerading, etc.

Returns
An IAddress provider.
def loseConnection(self): (source)

Close my connection, after writing all pending data.

Note that if there is a registered producer on a transport it will not be closed until the producer has been unregistered.

def loseWriteConnection(self): (source)

Undocumented

def pauseProducing(self): (source)

Undocumented

def readConnectionLost(self, reason): (source)

Indicates read connection was lost.

def registerProducer(self, producer, streaming): (source)

Register to receive data from a producer.

This sets self to be a consumer for a producer. When this object runs out of data (as when a send(2) call on a socket succeeds in moving the last data from a userspace buffer into a kernelspace buffer), it will ask the producer to resumeProducing().

For IPullProducer providers, resumeProducing will be called once each time data is required.

For IPushProducer providers, pauseProducing will be called whenever the write buffer fills up and resumeProducing will only be called when it empties. The consumer will only call resumeProducing to balance a previous pauseProducing call; the producer is assumed to start in an un-paused state.

Parameters
producerUndocumented
streamingTrue if producer provides IPushProducer, False if producer provides IPullProducer.
Raises
RuntimeErrorIf a producer is already registered.
def resumeProducing(self): (source)

Undocumented

def startReading(self): (source)

Compatibility only, don't use. Call resumeProducing.

def stopProducing(self): (source)

Stop producing data.

This tells a producer that its consumer has died, so it must stop producing data for good.

def stopReading(self): (source)

Compatibility only, don't use. Call pauseProducing.

def unregisterProducer(self): (source)

Stop consuming data from a producer, without disconnecting.

def write(self, data): (source)

Write some data to the physical connection, in sequence, in a non-blocking fashion.

If possible, make sure that it is all written. No data will ever be lost, although (obviously) the connection may be closed before it all gets through.

Parameters
dataThe data to write.
def writeConnectionLost(self, reason): (source)

Indicates write connection was lost.

def writeSequence(self, data): (source)

Write an iterable of byte strings to the physical connection.

If possible, make sure that all of the data is written to the socket at once, without first copying it all into a single byte string.

Parameters
dataThe data to write.
disconnected: bool = (source)

Undocumented

disconnecting: bool = (source)

Undocumented

protocol = (source)

Undocumented

def _readConnectionLost(self, reason): (source)

Undocumented

def _writeConnectionLost(self, reason): (source)

Undocumented

Undocumented

Undocumented